Fujifilm FinePix A101 Manuel d'utilisateur Page 38

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 44
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 37
7574
Troubleshooting eIf you think the camera is faulty, check the following once more
Problem Cause Remedy
No power.
i
The battery is exhausted.
i
The AC power adapter plug has come out
of the power outlet.
i
Replace the batteries.
i
Plug the adapter back in.
Power cuts out during
operation.
i
The battery is exhausted. iReplace the batteries.
Battery runs out quickly.
i
You are using the camera in extremely
cold conditions.
i
The terminals are soiled.
i
The battery is flat.
i
Put the battery in your pocket or another
warm place to heat it and then load it into
the camera just before you take a picture.
i
Wipe the battery terminals with a clean,
dry cloth.
i
Purchase new batteries.
No photograph is taken
when the shutter button
is pressed.
i
No SmartMedia is loaded.
i
The SmartMedia is fully recorded.
i
The SmartMedia is write-protected.
i
The SmartMedia is not formatted.
i
The SmartMedia contact area is soiled.
i
The SmartMedia is damaged.
i
The Power Save function has switched the
camera off.
i
The battery is exhausted.
i
Load a SmartMedia.
i
Insert a new SmartMedia or erase some
unwanted frames.
i
Remove the write-protection.
i
Format the SmartMedia.
i
Wipe the SmartMedia contact area with a
clean dry cloth.
i
Load a new SmartMedia.
i
Switch the camera on.
i
Purchase new batteries.
There is a strong likelihood of
camera shake because the shutter
speed is slow.
A protected frame was erased. Protected files cannot be erased. Unprotect the
frame using the camera on which the protection
was first applied.
Use flash photography. However, a tripod
should be used for some scenes and modes.
i
The data could not be recorded
due to a SmartMedia error or a
connection error between the
SmartMedia and camera.
i
The photographed image cannot
be recorded as it is too large to fit
in the available space on the
SmartMedia.
i
Re-insert the SmartMedia or switch the
camera off and then on again.
i
Use a new SmartMedia.
Warning Displays
eThe table below lists the warnings that are displayed on the LCD monitor
Warning Displayed
Explanation Remedy
The playback frame number has
reached 9999999.
Take the shot using a formatted SmartMedia.
DPOF settings are specified for an
image you tried to erase.
To erase the image, specify RESET as the
DPOF setting.
Prints were specified for more than
1000 frames in the DPOF frame
settings.
The maximum number of frames for which
prints can be specified on the same
SmartMedia is 999.
Vue de la page 37
1 2 ... 33 34 35 36 37 38 39 40 41 42 43 44

Commentaires sur ces manuels

Pas de commentaire